After another month....it's update time.

Here's an update on some trike parts and a few pictures and details.

The steering arm and stub axle, the stub axle was turned from a 22mm solid rod with a 25mm step at the steering arm end and an internal thread on the outside edge for a 10mm bolt as pictured. The steering arm is going to be a bit hit and miss but there's lots of room for adjustment etc. I cut, drilled (20mm hole for the stub) and welded the large 3mm plate for the disc brake and steering arm mount.

Here's a shot of the wheel/steering mount, fairly crud at this stage but again there's scope for lots of adjustment. Using 10mm rose joints and a 10mm x 90mm bolt. The rubber parts are from a plumbing supplies store and just a temporary solution.

All welded up ready for the 2 frames to be stripped back and powdercoated.